SERVICE - TESTING LEVEL A SUIT

  • Product Code: CLCH-LKL-YSVCE-
  • Item Code: CLCH-LKL-YSVCE-
  • Availability: In Stock

 

For service/testing booking contact:  

T: (+65) 6266-0788 | E: service2@noah.com.sg | W: www.noah.com.sg


Overview

Industry standards recommend that a visual inspection and pressure testing of Level A ensembles be done at the following times:

  • Upon receipt from supplier
  • At least once per year
  • After the garment is worn and before the garment is worn again

Note: Contaminated, damaged or altered garments should not be re-used.

Note: All suits must be decontaminated before testing at our service department

Maintenance and Repairs (Page 4 of manual)

Upon receipt, the Level A suit should be tested to insure that 

no damage has occured during shipment.


After that, the Level A suit should be tested after every use and at least annually,

whether it is used or not.


If the Level A suit fails the test, see “Testing” and “Returns” for more information. In addition to testing,

the Level A suit must be inspected after every use and at least annually. A Level A Inspection Checklist has been provided

at the back of this manual to assist in the inspection. When replacing exhaust valve diaphragms after testing or inspection,

care must be taken to insure that the diaphragm locking stem is secured properly into the positioning groove on the

stem. If the diaphragm locking stem is pulled too far into the valve housing (beyond the positioning groove) the diaphragm

may not seat properly. Visual inspection from both outside and inside the garment is recommended to assure proper seating

of the diaphragm. Check the zipper for overall condition, worn or damaged teeth, and ease of operation Lubricate zipper lightly with paraffin, which is readily available in most grocery stores. Paraffin should be applied lightly to the inner and outer elements. After cycling

the zipper several times, the excess flakes should be removed.

Do not use a sticky lubricant which could

 

 

Level A Test Kit for Lakeland Level A Suits

Style Number: 00010

Pressure test kit for Lakeland Level A suits.

Kit Features:

  • Pressure testing for Lakeland Interceptor® level A suits per ASTM F1054 and EN464 (Pressure testing for Gas-Tight suits).
  • Requires external air supply source.
  • Exclusive for Lakeland Level A suits.

Test Kit Part Numbers – PTK10

level a suit testing

Write a review

Note: HTML is not translated!
    Bad           Good